Vault Boy Spy and Carry Weight

Vault Boy Spy and Carry Weight

Have this model here - DOWNLOAD LINK 

Have this model here - DOWNLOAD LINK 

Have this model here - DOWNLOAD LINK 

These models were tested in Cura 15.06. To avoid printing problems, we recommend the following settings:

Quality:

• Layer height: 0.1mm*
• Initial layer thickness: 0.3mm
• Bottom/top pattern: lines
• Horizontal expansion: 0.04mm (when entering 0.04mm index, the 3D printer 
• *Layer Height 0.1mm is recommended for a better quality for the printed model. However, the printing time will double.

Check this Simplify3D User Guidelines to avoid any 3D printing problems with this software.

The models have been tested and printed out in PLA.

Speed setups:

• Infill speed: 50mm/s
• Outer shell speed: 30mm/s
• Inner shell speed: 20mm/s
• Top/Bottom Speed: 20mm/s
• Support speed: 50mm/s
• Travel speed: 150mm/s
• Skirt speed: 30mm/s
• Amount of slower layers: 4

Infill:

• Infill pattern: Grid
• Line distance: 3mm
• Infill overlap: 20%
• Infill layers: 0

Support:

• Enable support: check
• Placement: Everywhere
• Overhang angle: 30°
• X/Y distance: 0.7mm
• Top distance: 0.2mm
• Bottom distance: 0.2mm
• Stair step height: 0.5mm
• Join distance: 0.7mm
• Area smoothing: 0.6mm
• Use towers: check
• Pattern: Grid 
• Line distance: 1.5mm

Platform Adhesion:

• Type: Brim
• Brim line count: 10 (up to 20, depending on the model’s height)

Other 3D printing recommendations 

Outer Shell Speed - 20mm/s and Support Speed - 40mm/s settings apply to avoid model deformation. Use other settings by default.

Disclaimer: This model will look outstanding if printed on SLA/SLS 3D printer. The accuracy of the model printed on FFF printer can vary from the result shown in the pictures.

Have this model here - DOWNLOAD LINK